OutdoorKing Repair Forum Forums Repairs and Maintenance Questions on Engines Questions On Honda Engines Specs on GXV120 carb drain bolt??

Hi guys,

On the GXV120 carbs, theres 2x bolts that go into the float bowl. 1 that secures the bowl to the carb itself, and a 2nd that acts as a drain type plug?... does anyone have the specs on the drain bolt? Mine went walkabout so was just going to get one from hardware store with a washer and didn't want to have to get a kit.

Thanks

[Update] Took the bowl to Bunnings, looks to be an M6, so I picked up a pack of these..

https://www.bunnings.com.au/romak-m6-x-20mm-zinc-plated-hex-head-set-screw-8-pack_p2310661

A bit long, so will have to cut in half, but assuming that's ok, is a standard fibre washer ok to use with this ?

Sorry for the late respondance just seen the topic.

M6-1.00 x 8mm (thread length) is what I measured here. The one here also using a 10mm socket/wrench or a #3 Phillips (Cross point) driver to install or remove.

oh awesome, thanks AVB .

Yes, the standard fibre washer will do perfectly.

Awesome, thanks Bigted .