OutdoorKing Repair Forum Forums Collectors Corner Cylinder 14" SB45 help needed

Hi there,

I have a small problem with my scott bonnar 45. The bolt at the front inside the chain guard keeps coming loos and I don't know how to keep it tight. It's the bolt next to the blades.

The link is from bigfella78's post. It was the only way I could post the picture

http://s1354.photobucket.com/user/bigfella78/media/20151112_093322_zpsywidhwbt.jpg.html

Thanks in advance


Joeyvek

Hi,

Are you referring to one of the bearing carrier bolts ?

One thing to take into consideration does it have a serviceable spring washer ? if not then put one in place and you'll find the problem eliminated.

Cheers,
BB.

Thanks bb I will have a look later in the week

Hi guys

I need help again. I have a 1968 model sb45 but I have lost a part off the motor while I was replacing the coil. It was a flat piece of metal that had a spring attached to it that went to the throttle cable on the carby. Just winding where I can get these parts from.

Thanking you in advance
Joey

1968 14 inch scott bonnar 45

try calling alberts mower center in beenleigh 07 3807 1347 speak to brad
bought some parts from them i think it is call blade-governor or air vane governer