Hi,
What would be wrong with the choke as all it does is operate a butterfly right below the lever that you move through 90 degrees. Positions are as follows, off pointing to the right as view from behind the machine, 45 degrees half on and 90 degrees full on. (in line with the manifold)
If it doesn't smoke like a train and has good compression then you've got a good one. How much free play is there in the main butterfly shaft as this is where most of the Kirby's problems arise ? BTW yours probably looks worse than it really is due to it being left out in the weather and not having worked its backside off.
As far as Powder Coating is concerned, I'm definitely not a fan as its hygroscopic which means it sucks in moisture which in turn creates rust between the surface coating and the substrate metal. This issue doesn't really affect paint that much. Powder Coating is done purely as a more economic method in mass production and less trades people involved which equals less money paid to employees, thus more profit.
Good rust removal, proper primer and a good top coat wins every time.
Yes you are correct with the trends of cylinder mower ownership in Victoria, it's rather low compared to the other warmer states and that should give you a bit of a clue as to why more of them are in SA, WA, NSW and QLD. Melbourne was traditionally a much colder part of Australia in the 1960 and 70's when most of the 45's were being built, but of course it was like that way before the 45 was ever conceived.
I'm sure you'll find someone in Melbourne that does that type of work. Just go to your local bowling club etc. and ask where they get theirs done and I'm sure you'll get a great result.
Cheers,
BB.
BTW. That fuel tank modification on the twin railer is a beauty. In the case of that machine it's been done due to the fact of a Briggs being fitted and the fuel tank not clearing the handlebar as that machine originally had a Kirby on it also and they had the tank sitting forward. It wasn't until SB crossed over to using the Briggs engine over the full range that they had to alter the lower handlebar section with a kink to clear the 1 Quart fuel tank.