[Linked Image]
[Linked Image]
[Linked Image]
[Linked Image]
[Linked Image]
[Linked Image]
[Linked Image]
[Linked Image]
Total thickness of washers is approx 1.6mm
[Linked Image]
[Linked Image]
[Linked Image]
Thread this the same size as the kill switch hole
[Linked Image]
[Linked Image]
[Linked Image]
[Linked Image]
This is your new idle adjuster screw, this is the 2nd bolt you cut earlier to 18mm

Last edited by NormK; 05/02/17 12:16 AM.