Hi Jack,

I thought I would post up some pics of my SC KXD-2 blade holder. Finally cool enough to walk over to the shed today! There has been a very real risk of heat stroke just walking outside to fetch the mail lately!

Some dimensions first.

Distance between centres of outside holes: 300mm

Distance between centre of central hole and centres of outside holes (straight): 150mm

Distance from centres of outside holes to rim: 21mm

Central hole diameter: 12mm

Outside holes total diameter: approx. 21mm
Polythene "cushion" thickness: aprox. 2mm (Was this cushion made of brass originally?)
Bushing outside diameter: 15mm (note bushings are also "wrapped" perhaps due to wear?)
Bushing inside diameter: 10mm
Bushing length: 22mm

Blade holes each braced on top side of disc with 20mm X 30mm X 20mm (X 6mm high) brace.

Blade holes raised approx. 3mm from plate surface on bottom side.
Blade holes raised approx. 13mm from plate surface on top side.

Blade plate has a 12-13mm flange angled up approx. 45 degrees on outer rim.

Here are pictures of the bottom of the blade holder ("plate"):

[Linked Image]

[Linked Image]

[Linked Image]


And here's the top side of the blade holder ("plate"):

[Linked Image]

[Linked Image]

[Linked Image]


P.S. I guess there is a very real possibility that my blade holder is not original?


Last edited by vint_mow; 28/01/17 09:36 PM.