OutdoorKing Repair Forum Forums Repairs and Maintenance Questions on Engines Questions On Victa Two Stroke Engines Powertorque - Small End Bearing Replacement

Hi all,

trying to replace the conrod bearing on my Victa PowerTorque motor. The upper bearing that the gudgeon pin goes through. Does anyone know where i can buy this part? having trouble finding it anywhere.

Only seen one for sale on ebay and from memory they wanted over $40 for it. Find another complete mower and either swap the motor over or pull the conrod and bearing out and use that

Yes as Norm says a donor engine is a cheaper way to go.

That is if you live in an area that you can still get them for less than a $100�

Ps. Do you mean the conrod little end bearing? If so, that is only available as an assembly. You could also try a bearing supplier.

Here is a parts list: (See page 20) Victa PowerTorque Parts Manual (1990 - early 2000's)

LRT for $100 I would want a near new one, plenty around for $15/20, motor with years left in them, but body or wheels trashed

It's interesting the pricing is a lot cheaper in the city compared to rural areas.

Victa

Must admit I do chase around after them a fair bit but they are out there, I drove to Portarlington to pick up a Victa 24 cost me 7 hours for the round trip

Click HERE for your bearing.

The big and little end bearings are available from OutdoorKing.