|
|
|
0 members (),
1,174
guests, and
469
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
Joined: Mar 2011
Posts: 57 Likes: 1
Trainee
|
Hi guys,
I need to remove the one-piece conrod from a Victa Powertorque engine. I took off all the easy stuff, now the pin the secures the piston rod to the flywheel is what I think is next. I'm not too sure if it is screwed in clockwise like a normal screw or anticlockwise. I'm going to use a metal pin and a hammer to do the job and I don't want to damage anything.
Many thanks!
Max
|
|
|
|
|
|
Joe Carroll
Unregistered
|
It works as a normal bolt, righty tighty lefty loosey, 
|
|
|
|
|
Joined: Jul 2005
Posts: 6,362 Likes: 11
Administrator - Master Technician
|
Ahh Joe...you are a devil!!  Happy St Paddy's Day for tomorrow, mate! 
Please do not PM me asking for support. Please post your questions in the appropriate forums, as the replies it may receive may help all members, not just the individual member. Kindest Regards, Darryl 
|
|
|
|
|
Joined: Mar 2011
Posts: 57 Likes: 1
Trainee
|
|
|
|
|
|
|
Joined: Mar 2011
Posts: 57 Likes: 1
Trainee
|
Hi guys,
removing the conrod was actually easier than expected!
Would you install a standard or an oversized piston? The cylinder has not been rebored but the engine is at least 10 years old.
Thanks,
|
|
|
|
|
|
Joe Carroll
Unregistered
|
If theres only small scratches if any, I have thrown a set of std rings in one thats 30 years plus old before.
|
|
|
|
|
Joined: Mar 2011
Posts: 57 Likes: 1
Trainee
|
All done!
Many thanks for your support!
|
|
|
|
Forums145
Topics13,080
Posts107,356
Members17,919
| |
Most Online16,069
Sep 18th, 2025
|
|
|
|
|
|
