OutdoorKing Repair Forum Forums Finding and Swapping Wanted ARCHIVE: Scott Bonnar Model 40 Catcher Mounts

Would be very grateful if anyone with a Scott Bonnar Model 40 catcher with original catcher, could post a pic of the catcher's mounting plate, where it slots into frame. I have a catcher but previous tenants "improvements" give me little too work off, so that I can have new "original" mounting brackets made.

My catcher is good but sure that SB did not send unit from factory with gal bolts with square nuts as the mounting points for the slots in the frame body.

These photos show the connectors on a Scott Bonnar Model 40 catcher which fit into the slots on the side plates. After a lot of use they often needed strengthening and repair.
Regards,
Grant.

Thanks Grant, once again mate, you have saved the day....Cam will be a happy chappy...

Thank You very much Grant.

It is greatly appreciated!

Perhaps my brother wont receive catcher on Fathers Day but wont be too far off in future.

Grant you are a legend. I could never have guessed that the brackets looked like that from my mangled remnants.

Thanks again,

Cam

This topic is Closed and Locked.
This topic has been archived.