|
|
|
0 members (),
1,698
guests, and
1,315
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
Joined: Dec 2001
Posts: 30
Novice
|
i put a victa 160cc together and had no control over the speed. i couldn't turn it off and it was reving way to fast. i have checked the carby and adjusted the screw in the wearplate. what else could it be?
|
|
|
|
|
Joined: Dec 1999
Posts: 5,433 Likes: 36
Repair Junkie
|
Please advise me if it has a black plastic carby?
Regards,
Bruce
Regards, ![[Linked Image]](https://www.outdoorking-forum.com.au/forum/images/members/mower-monsterw.jpg) Bruce Please do not PM me asking for support. Post on the forums as it helps all members not just the individual.
|
|
|
|
|
Joined: Dec 2001
Posts: 30
Novice
|
yes it is a black carby. it has an a, b or c speed setting. i was told to put in on c. i adjusted this yesterday as it was on a or b, but now the engine runs for less than 3 seconds, if that. it also looked like there was petrol leaking out of the decompressor. is one of the hoses supposed to go from the decompressor to the vaccum?
|
|
|
|
|
Joined: Dec 1999
Posts: 5,433 Likes: 36
Repair Junkie
|
Macca,
E-mail me on Spare parts section this site & I will forward you information needed to get you going again.
Regards,
Bruce
Regards, Bruce Please do not PM me asking for support. Post on the forums as it helps all members not just the individual.
|
|
|
|
|
Joined: Mar 2002
Posts: 3
Novice
|
check that all vacuum hoses are in good cond and connected properly. if they are, replace starter housing o ring and carby manifold o ring. see how this goes.
|
|
|
|
|
Joined: Jan 2002
Posts: 27
Novice
|
Macca
Make Sure that you have connected the throttle cable properly inside the carburettor. These can be difficult to re connect.
Regards
Ben
|
|
|
|
Forums144
Topics12,738
Posts106,722
Members18,007
| |
Most Online40,124
Apr 13th, 2026
|
|
|
|
|
|
