Murray - TAS - G'day All - OutdoorKing Repair Forum

G'day All,
I've just joined this forum. I wish I had found it years ago.
I enjoy repairing small engines/mowers as a hobby.
I'm looking forward to speaking to you and I'll try to contribute to the forum when I can.

Cheers
Murray

Last edited by CyberJack; 07/02/16 08:22 AM. Reason: Topic heading.

Cheers, Murray

Portal Box 6

Re: Murray - TAS - G'day All

Murray #15317 14/12/09 04:29 PM

Joined: Dec 1999

Posts: 5,434

Likes: 36

Sydney, NSW, Australia

Bruce

Repair Junkie

Hi Murray and

aboard to our forum. We all here enjoy fixing, restoring equipment and helping others fixing their equipment. We especially like members that post pictures of their work so we can all see their work in progress.

If we can be of any help just post on the forum and we will do our best to help.

Once again

to the forum.

Regards,

Bruce

Please do not PM me asking for support. Post on the forums as it helps all members not just the individual.

Re: Murray - TAS - G'day All

Bruce #15322 15/12/09 01:15 AM

Joined: Jul 2005

Posts: 6,362

Likes: 11

Wagga Wagga NSW Australia

Deejay

Administrator - Master Technician

Hi Murray, I wish to echo Bruces thoughts as well, mate, as we all love to learn new things and tinker here....and your input will be much welcomed on the forum.
Once again

Please do not PM me asking for support. Please post your questions in the appropriate forums, as the replies it may receive may help all members, not just the individual member.
Kindest Regards, Darryl

Re: Murray - TAS - G'day All

Deejay #15356 16/12/09 03:57 PM

Joined: Dec 2009

Posts: 73

Hobart, Tasmania

Murray

Trainee

Hi all,
Thanks for the welcome.
I have no photos of my last project. It was a Honda Buffalo mower with the GXV140 engine.
This mower was about 14 years old and had seen a lot of use but was in very god overall condition.
It had lost compression and was very hard to start.
I only had to give the bore a hone, new rings,replace the crank shaft roller bearing, cleaned the head and lapped the valves,new gasket kit, new blades.
All up cost was $240 for the rebuild. Now runs like new.

My past projects include another Honda, some Victa's, Stihl chain saws, McCulloch chain saws and some Briggs and Stratton engines.
Also have done a couple of Fergy 28 & a 148 tractors.

My newest project will be a Greenfield 12 ride on mower.

Cheers
Murray

Cheers, Murray