Hi I have a Mimi bike it has a victa 160cc engine with a MOLKT carburetor, i want to fit a Decompression Valve to the cylinder head to make it easier to start (as it has a lot of compression) but I'm not sure where to connect the Decompression Valve's vacuum tube to the carby ? The carby has two vent tubes should I be connecting the vacuum tube to one of these tubes ? Thanks
Hi Ghost, welcome here. I assume you are talking about a full crank motor? You will have to connect the vacuum line into the manifold if you have enough room, otherwise you will have to drill a hole into the carby throat just before it enters the manifold.
