OutdoorKing Repair Forum Forums Repairs and Maintenance Questions on Engines Questions on Other Engines Villiers Engine Numbers

Seems as though it the cylinder was 180 degrees around it could fit a motor bike. Sorry best photos I have too.

AUS Spec Midgets
OPERATING & PARTS LIST

The rest is history.
---------------------------------
JACK.

Going back to the earlier pics , the crankcases marked 764 I believe are a Villiers 79 cc supplied only to Atco for reel mowers between about 1949 and 1960. Rope or kick start, 1454 type mower.

I have an incomplete Villiers Torque Major engine, type 140/01/09, serial 130480. What were the standard fitments on this engine?

Hi All

Just throwing in another engine number if any one can help Villiers 7F No.. is 119D 13380 engine is on a Pace 2A automatic, does this mean that because it doesn't have an X but a D instead it is imported or am I reading the posts incorrectly.

thanks mich

Hi Mich
That's the way I read it.

I found this note at the end of a 7F listings doc: -



Hope this helps
---------------------------------
Jack

Thanks for your help Jack

Not sure if you have seen the pic at the bottom of this web page:
https://salterbros.com.au/villiers-australia/

I didn't copy the pic due to copyright

Australia must have a lot of 7F's floating around if this is only 1 load.

mich

Hi Mich
I remember I did a lot of research when I wrote this article: -
https://www.outdoorking-forum.com.au/forum/ubbthreads.php?ubb=showflat&Number=51174

These images appeared in Villiers Magazine, and copyright
is no longer in issue.

Cheers
----------------------
Jack

Hi Jack

I was pretty sure you would have seen the pic, I don't know why I didn't look in History Forum thank for pointing me to it.

I noticed in a villiers manual that engines could be dated and spec'd by the engine number, do you know if there is a listing anywhere for this as I haven't been able to find anything.

thanks

mich