OutdoorKing Repair Forum Forums Repairs and Maintenance Questions on Engines Questions On Briggs & Stratton Engines Modification to Throttle Controller and Cable

I am sure I am not the only one to do this but it might help someone. I have the usual throttle controller but no matching cable. This is the usual pair:

However, the cable I had was the type where the spring metal sheath is bent to fit into an anchor hole and that cable doesn't fit into the common controller. I found they would fit and work OK if I drilled a small hole in the controller like this:


After that you can simply fit the right angled anchor point into the hole that was drilled.


I hope this helps someone.

Didn't realise the photos would be that big and er,,, that's my thumb.

Good call there sparker, I had never thought about doing that but I will keep it in mind