I've actually seen something done to the height adjuster itself. Bit like a washer welded on with a "pointer" that moves up and down with the shaft as you twist the adjustment handle. Two lines on the side marked with the cutting heights. Either way I'll figure something out before spring hits.
Everything came back today from the blasters. Also managed to get my handle bars back from the Chromers as a well! Done a lot of running around today, I'll tell you!
Pictures of some parts are attached. See what you reckon. I've got nothing but good things to say about the job on first look. Will start putting it back together tomorrow. Unfortunately, I have put some pinholes in the fuel tank when on the wire wheel. Have some JB Tank Weld to try and fix the problem because it all runs otherwise after being pulled apart and refreshed.
I don't collect mowers. I just require Multiple Mowing Solutions™.
