Thanks Jack.
Quick response, much appreciated.
I can't quite see how to drop the cutter deck (mine is the steel one) to allow for enough room to reset the belt.
Is there a description in the operators manual?
Perhaps I am not approaching this correctly.
The pulley at the front of the mower, on the bottom of the motor, that drives the cutter, is very close to a rod, with little room to move the belt back onto the pulley.
Can I drop the deck to replace the belt, or do I need to remove the deck entirely?
Any help you can provide is appreciated.
My approach has been to tip the mower on its side to access the bottom. Is there a better way to do this kind of work? Does it need to be on axle stands and upright?
Cheers,
Scott
