Thank you Bruce.
I have purchased a new snorkel from Bruce, but it seems to be a little longer than the length shown in the model photos and diagrams, as though it now needs to be cut to its correct size (whatever that is).
Unfortunately, I do not have the original factory-fitted snorkel.
Also unfortunately, I don't have the experience to know when it is "nearly" running correctly, so I could end up cutting too much off.
Perhaps the Model 5 snorkels were all made to the same length, even though this was not stated in the Victa documentation.
Q. Could any forum members who own a Victa Model 5 please advise me the actual lengths of the rubber snorkels on their mowers, and how/where the lengths were measured. Perhaps there will be some consistency in the lengths.
I would then feel a lot more confident about cutting the new snorkel, and knowing the motor is running in its intended state.
Any advice greatly appreciated.
Thank you again Bruce.
