Hi Guys,

I was just working on this mower. The engine after some repairs is going sweetly however I flipped it over to clean underneath and replace the blades and I encountered a problem. The photos are pretty self explanatory. It came to me with only one bolt holding the plate onto the boss. The 3 small bolts were not installed.

I have tried to get the centre bolt out but it is stuck solid. Unfortunately I have burred the sides a little.

I am hoping somebody could share a trick because this mower runs really nicely and I dont want to move it on before I fix the blade plate area. Hoping its a reasonably easy fix.
[Linked Image]
[Linked Image]
[Linked Image]
[Linked Image]