Hi there. I am having a small issue with the fuel line on the Greenfield. It has an 11.5HP I/C Briggs.

It started when I put the in line fuel filter in. It is a clear case with pleated paper inside.

I have run out of fuel on two occassions and it will not draw fuel from the tank. I have to suck it through the line. If I remove the filter it is fine. The wet paper causes too much of a restriction to free drain but I would have thought the gravity feed of the tank level being above tha carb would solve it.

Any ideas on a simple priming system? Are they available?

I am guessing the red round "spinning top" type Briggs filters are a mesh design?

Last edited by aldot; 28/04/11 03:35 PM.