Thank you for your reply bigted.
Could I bother you again on the wiring issue to clarify correct connection?
Both my two wires going into the carburettor for the stop/start mechanism are both black in colour and I just want to know whether I have the correct ones connected correctly!
Currently the other end of the βgroundβ wire (with the flat brass electrical connector), I have connected through the centre end of the black rubber boot with a black rubber plug on the end of this wire going into the carburettor entry point.
The other wire (currently going to the ignition coil) I have the other end inserted into a hole in the side of the black rubber boot which is 90 degrees to the other wire.
Are these two wires correctly fitted into the carburettor stop/start mechanism or should they be reversed?
Thanking you in anticipation of your reply,
Lecky23
