No go, there isn't enough clearance to get enough leverage.

I've taken off the wheel, the flangette bearing and half the flange bracket.
How would I go about taking off the actual bearing? The other half on the bracket wiggles but won't budge. The bearing can freely spin. The collar/race? part won't budge and with the 3 cuphead bolts sticking out, a puller can't get enough grip.
There isn't any grub screws holding it on to the shaft.

Is there a trick to it or should I cut the bolts off to get more room to use a bearing puller?

[Linked Image]

Attachments
IMG_2610.JPG (183.21 KB, 51 downloads)
Last edited by RogerWilco; 04/10/20 05:38 PM.