OutdoorKing Repair Forum Forums General Discussion Forum Off Topics Should I Get a Brand New PT While I Can?

I am considering the same thing MF, going to put a new piston (worn where gudgeon is) in a very nice Sunbeam Lawnkeeper 160.

At sca, there is a big hone for $74,
or a small one for $28.

The big one will do down to 50mm, a 125cc is 53mm. 160cc is about 62mm from memory.

So I suppose it is a matter of deciding if a larger one is worth it for any other uses like motor bikes or car engines

I’ve been considering a full rebuild for some time myself, I know a tool maker who can bore a couple of badly scored blocks for me. There are a few places online where you can buy ball type/flex hones for around the $80 mark. I guess it would cost me about $150 all up for the hone, oversized piston, rings etc. but would be a great project and I would know what I’m getting at the end of it

I got a couple of new sets of stones for my hone yesterday this time I went for the 100mm ones and they are nice and thick, should be able to do a lot of cylinders with these. If you are going to get a hone be careful, most of the ones on ebay only have 50mm long stones and when you are using it the stones can drop into the transfer ports so the min stones you can use are 75mm long, not easy to find but you should be able to pick one up for the mid $30 range

Hi All,

Well the first one sold with a Buy it Now price of $250. The second one is now up for Auction, see link below.

https://www.ebay.com.au/itm/VICTA-vsx160-lawn-mower-engine/264261075363?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m1438.l2649

It'll be interesting to see where this one gets to as there is a third one to come up after this one.

Cheers,
BB.

I can only say I am gobsmacked, but I guess in here we get used to just rebuilding a motor and give it little thought apart from the fact it has cost you a set of rings or a pull starter or whatever.

Jmagine if anyone had 3 brand new Holden 308 Engines to put up on eBay one by one.............wouldn't we all watch them fly to dizzy heights ?

I can't imagine what it would cost to rebuild a 308 these days, haven't had one of those rebuilt for probably 25 years and back then it cost me a couple of thousand dollars

Try tripling that now and that's just for a standard variant.

The second Brand New PT finished up at $172.50 which is far less than the previous listing with the BIN fixed price which fetched $250.

I expect the third unit to be listed at the original $250 BIN figure again.

Cheers,
BB