OutdoorKing Repair Forum Forums Repairs and Maintenance Questions on Edgers Two Stroke Edgers Victa Tilt-a-Cut Edger - series 80

Thanks for that CyberJack. I don't know why that link didn't work for Sherrie - it still works for me - but you've saved the day.

Hello CyberJack

I'm sure Grumpy will be fine with this. My PDF Reader works fine, I'd never had a problem previously. I've just clicked on the link that you're so kindly attached and this link opens up perfectly.

CyberJack, may I ask about the other link that Grumpy had provided, when you click on that link as I mentioned it opens fine. Scrolling to the bottom of that page give another link which reads:

Attachments
Victa Early Tilta Cut Edger.pdf (152 downloads)
Description: Victa Old Edger

CyberJack, is this the same as your attached Link ? I'm trying to ascertain the size Belt that I need for my Victa Tilt-A-Cut Power Edger, the Model Number is CA901A6. Again, Thanks CyberJack. Kind regards, Sherrie

Sherrie, it depends whether you have an early or late Tilt-A-Cut. Here is the page from the Outdoorking Online Store:

https://www.outdoorking-forum.com.au/index.p...eyword=tilt-a-cut+belt&x=18&y=11

As I understand it your CA901 Tilt-A-Cut was made from 1987 to 1995, and uses the ME 63230A belt - see this parts sheet:

http://www.powertoolspares.com/tool...krefoldmodels19871995/fg406-5000/spares/

Hi Grumpy, Thanks for this link, I'll check it out. Regards, Sherrie

Hello Grumpy and CyberJack

I've been in contact with www.outdoorking.com and I must say that their On-Line Chat gentleman and Service was wonderful, his name is Bill. Grumpy, you were spot on with the Model Number of the Belt that I needed for our Tilt-A-Cut Edger. Bill asked me to send a photo of our Edger, which I did, and he has confirmed the part. I've now ordered and paid for the Belt.

I hope you don't mind, but I have another question relating to the installation of this Belt as I'm hoping that you will be able to guide me with this, as I've never replaced the Belt. Yesterday for quite a long period of time (hours and hours) I had been on Google trying to find the answer to installing the belt, I never thought that finding this type of information would be so difficult. This morning, I found your Web Forum (how lucky am I !!) Thank you both, so much for all you have done at this stage, in helping me. Sherrie.

The instructions for replacing the belt are in the owner manual you've already downloaded, Sherrie. Here they are:

Hi Grumpy, Thanks again for helping me with my latest enquiry.

I wasn't able to download either of the links that you had so kindly sent, and then CyberJack sent a message and another Web Link which you'll recall, but the information on that link, didn't have this information, so this is the first time I've seen this.

Hey, thank you Grumpy! I'll be right now. Hope you and CyberJack have a great evening, gee "that weekend went quickly". Kindest regards to all. Sherrie

Let us know if you run into any problems, Sherrie, and we'll see if we can help, but as you say, you'll most likely find no difficulty now.

Hi Grumpy, I sincerely appreciate all the communication and wonderful assistance from this Forum. I know that without this Forum and the guidance, I wouldn't have been successful in achieving this outcome. Thanks so much for all the support. Kindest regards, Sherrie

Thanks for the kind words, Sherrie. I'll close this thread. If you have future questions about the Tilt-A-Cut or any other outdoor motorised equipment, please open a new thread.