OutdoorKing Repair Forum Forums Finding and Swapping For Sale SEVEN Victa Utilities

1 x Victa MasterCut 460 - 4 Stroke Briggs and Stratton 500 Series Engine
2 x Victa Mastercut 460 - 2 Stroke Power Torque Engine
1 x Victa GTS V35 Utility - 2 Stroke Power Torque Engine
3 x Vitcta 2 Stroke Power Torque Utilities Not sure of the Exact Model

Located in Western Sydney

I've got them listed in all the usual places for $250, but I'd rather they go to a good home, so if anyone from here wants them, you can have the lot, all seven of them, including the MasterCut 460 4 Stroke - for $150

I've collected these over the years with the intention of restoring them all. I was going to do nut and bolt restorations on them all (exccept the 4 stroke which I have been using to mow my lawn) and paint them in stupid colours and do a kind of "Pimp My Mower" Project. But I'm moving overseas, so they've got to go.

All Engines are free, although one of them is quite tight and the all had spark but I never tested No 5 for spark as it was a bit too tight to spin freely to check the spark.











Looking at the photo from Left top Right:

First on the Left: The MasterCut 460 4 Stroke runs fine - I mow my lawn with it although it does surge a bit can be a bit hard to start after a long lay off.

Numbers 2 and 3: MasterPro 460 and V35 GTS - these are in reasonable condition and will be easy to get going.

Numbers 4, 6 and 7: A bit rough, but not seized and my intention was to restore them for use.

Number 5 is rough as guts, and might be too far gone to restore - maybe a good parts mower for the others, but having said that, if you are as silly as me, it might be fun to restore.

I've got a bunch of other Victas lying around too if you're interested (although not included in this Victa Utility Sale)

Come and have a look.

If you want them - I'll also throw in a couple of running PowerTorque Engines.

I've also got a couple of Corvettes

And a couple of Corvette 2s

And quite a rare beaste as well - the very early Victa Self Propelled - which I have started stripping to restore, but sadly, that too has got to go.

And an quite interesting Pope Rotary Valve model......they've all got to go....

If this was Melb I would be all over it but Sydney puts it out of range