I had to replace spark lead, so had to take it apart, one screw didn't want to undo, had to cut an extra groove for a flat screwdriver and use penetrating spray. I put another lead on but without boot.. good spark. Had to take plastic handles off as throttle cable was not engaging... the holding screw for the cable end had broken, drilled a hole and put a screw on to hold cable end. Those plastic parts break, plastic welded the sides....eventually put it back together..... I had the end head unit facing upwards............. So I unloosened everything and turned it around.... . And this is what I ended up with..... Now the throttle was on the wrong side...... Bugger, I just want to see if it fires up..... fuel overflow line, just hung it out the back..... It fired up , 2nd pull...... ran well.... for 5 min.... good to just run the engine to loosen up everything. Then the throttle cable stop buggered and I had no throttle........ More work needed, but I have another LT26, yes it's a 26 cc..... that fell off a truck literally and broke a lot of stuff...... I gotta get one going.......out of all these parts. cheers speedy
........................Keep your blades sharp......................
