Yep, the bearing separator type puller is the type that Victa used to supply as a factory service tool.

See this excerpt of a Victa Workshop Manual, 8th page; https://www.outdoorking-forum.com.au/pages/V...icta%20Workshop%20%20Engine%20Manual.pdf

Note also that the manual says:
Quote
If this tool is not available the bearings may be prised off with two screwdrivers.
That usually works, except for the occasional very tight bearing.

Cheers,
Gadge

"ODK Mods can explain it to you, but they can't understand it for you..."

"Crazy can be medicated, ignorance can be educated - but there is no cure for stupid..."