Hello again,
My SB is now in pieces, & have encountered a little problem removing the clutch housing from the engine crankshaft.

I have studiously watched your video (& read a couple of posts) to try & solve the problem myself, but no joy as yet.

My question is in relation to the 3 screws on the clutch housing (see photos below).

[Linked Image from i1252.photobucket.com]

[Linked Image from i1252.photobucket.com]

In the 1st photo, is the cotter pin - I have tapped this in as far as it will go & subsequently have no luck trying to tap the clutch housing off the shaft.
I don't understand what the other 2 bolts do (in 2nd photo). They are 2 bolt shafts sticking out from the blue casing, with nuts on them (when I unscrew the nuts, the bolt shafts remain in place). Do you know what they are for & do you think they might have something to do with me not being able to remove the clutch?
Cheers,
Lewy71