Hi Again
Removing flywheel easier said than done. There is a big round bush 1st to remove with a hole on its side, and for the life of me i cannot budge it.. its thread is rusted solid. I need to remove this bush to get the flywheel off. Currently the motor is out and i have the bush end sitting in a small cup of crc lubricant hoping it will help loosen but it tell ya its solid.
Have Also removed the top starter cord assembly found top o ring had blow by .. renewed replaced and reassembled.. also removed head waiting on new gasket ..bore looks smooth.. so all good there...So mission is still to remove lower bush.. wish it was a nut not a bush... nothing to grip on ..any idears on getting this off???
Oliver
