I have a tecumseh engine mounted on a Victa Imperial Barrel mower.
Model: HK25
Spec. No. K1033
Ser. No. 92517707
I recently installed a new coil and the engine starts OK but won't run under load requiring more throttle.
I suspected the points, pulled them out, resurfaced them, then put them back.
I can see how to adjust the points gap and advance/retard while I have the flywheel etc removed,
but when it is re-assembled, there is no access. The cowling, starting reel and fuel tank all need to be removed to
access the points etc then have to be re-assembled to run the engine. The flywheel/magneto completely hides the points etc.
My problem is, how do I set the points to operate at the correct angle before TDC?
Michoolie
