I am tryng to correct a problem where the carburettor screws have been messed around with to the point where the motor does not have ignition.
i have read the owners manual under "adjusting carburettor -general" but everything i seem to do does not work. And because im trying to start the motor it often gets flooded.
Is there an easier set of insturctions to get the carby set or is it all just a game of guess?
the manual state:
1. Turn HI and LO adjustment screws (C) and (B) clockwise until
seated lightly in carburetor body. (this is barely screwed in position i presume?)
2. Turn (B) adjustment screw counter clockwise 1-1/8 turn.
3. Start engine and allow it to run at high idle until warn (approx. 2-3 minutes).
any help?
