All the 3 holes where the bolts are mounted on the engine starter cover coincidentally becomes unusable as it can no longer hold the bolts (See photo to make it clearer). I then fabricated from a metal sheet pieces to follow the contour of the cover and connected it using a number of rivets. Drilled a hole to suit the size of the bolts and successfuly mounted it back to the engine body, There are 3 bolts that hold this starter cover to the engine body. However, i only have 2 of the original screws and the 3rd one i bought from the hardware store has a UNC thread measuring 1/4" by 3/4". The bolt fits in on engine hole and i can tighten it well but then when the engine is running, the bolt seems to loosen up so i was wandering if this is the right thread and measurement.
