Hi MW,
Originally Posted by maxwestern
I don't think a rattle gun would be any good with the drill end ,7000 rpm is a little fast and the impact action
would probably break drill bits Mf. The air ratchet works good as a drill though ,it's handy getting into tight spots
like under car dashes etc.
Well; it's one of those things that 'can be done, but shouldn't be!' WRT 'good workshop practice', that is...

I have used a rattle gun and 90deg gearbox, to drill a set of mounting bolt holes in an FJ45 Tojo Landcruiser's chassis rails, to fit a later model spare wheel carrier.

It was pretty rough on the drill bit's cutting edges, but that was the only way to 'get 'er done'.


Cheers,
Gadge

"ODK Mods can explain it to you, but they can't understand it for you..."

"Crazy can be medicated, ignorance can be educated - but there is no cure for stupid..."