Hi

I followed Tyler's instruction to a tee, except for the rubber grommet. I had to drill a fairly big hole, 7 mm from memory. You can then see I just rubbed it a bit with a file as it had some burrs.

I just used the 5mm wire rope grip instead of the 3mm Tyler linked to above

https://www.bunnings.com.au/zenith-5mm-stainless-steel-wire-rope-grip-2-pack_p4220127

I bought this pvc coated metal cable

https://www.bunnings.com.au/pinnacle-3mm-x-10m-galvanised-pvc-coated-wire-rope_p4310810

Essentially you just make a loop, tie off the loop with the wire rope grip and tuck thr loose end of the cable back in to the 19mm pvc clear rubbing you see in the bench grinder photo.

You just can't see the tie off with the wire rope grip as its tucked under the insulation sheath in the photo. You just tighten the grip with a 4mm ring spanner and it seems to bite really hard on the cable

It's just like the photo below I found online

I just layered the plastic coated wire in to the pvc clear tube and then over the top the insulation tubing that Tyler recommend.

That insulation stuff Tyler is a nice touch and really plush to handle.

Three cheers for Tyler's he's the man !

Thanks

Attachments
IMG_20200320_204746.jpg (44.72 KB, 18 downloads)