Hi Converse,
been a few years since I fitted the Rover catchers to the Victa high arch, From memory I made up a new flap from a piece of sheet metal and then I riveted that to the existing flap to extend the flap out with a turndown to grab onto the catcher. I also had to cut a bit out of the tounge in the left corner to clear the high arch section. Wish I had a few Rover catchers at the moment because I have a few High arch that I could put Rover catchers on. Buckets of catchers here and nothing I can use. The Rover catcher on the High arch is a perfect fit
I usually throw the high arch bodies out,pity because the bodies are much better that the steel pressed ones but without catchers they are useless to me. I usually just pull the motors off and fit them on slashers, about all I can do.

Last edited by NormK; 27/08/19 06:02 PM.