I assembled the rear axle , patched the whole. Took off the front axle, sheared a bolt, drilled it a bit, but it was through a aluminium lug so I couldn't wack it and break the lug off, so I ground flats on each side of the bolt and it loosened....cleaned up the axles, greased them with plastic bushes......put together, adjuster works well now.. haven't finished yet... See the rust in that bush.....that's why they were siezed... Old machines are a chalange, but it's a blast to see them even half restored like I do...... and reuse them. speedy
Last edited by speedy; 27/08/1905:43 PM.
........................Keep your blades sharp......................
